1. The connection between the crankshaft and the body and the impact connecting rod is made of high wear-resistant alloy copper pads, which have large bearing capacity, long service life and low maintenance cost.

2. The body is cast with alloyed ductile iron 500, with high tensile strength and good wear resistance.

3. Adopt two-stage gear transmission system, high transmission efficiency and large transmission torque.

4. Equipped with pneumatic clutch brake to reduce motor power consumption.

5. The cutting system adopts the S plate to drive the cutter bar, the S plate reciprocates, the cutting force is transmitted in a straight line, the force is large and stable, and the dynamic balance is good.

6. The clamp system (spring clamp and air clamp) can be turned 180 degrees or 90 degrees or translation. Conducive to molding process arrangement.

7. Equipped with frequency conversion speed regulation device, which can stepless speed regulation within a certain range.

8. Equipped with fault detectors and safety protection devices, it will automatically stop when the equipment fails, giving the equipment and tools maximum protection.

9. The feeding box is equipped with a thrust device to improve the feeding accuracy.